I was only able use the DCI file on Chankast .2a. What I did is I copied the VMS Browser from my .25 folder to my .2a folder. Then I opened the VMS Browser (in .2a after saving the .dci file in the same folder). U should see a current save state for MvC2 when u open the VMS Browser. After u see that, import the new .dci save state (it will prompt you to "replace?" the current one) then click on "Write" button. That should do it. I do that before I run the emulator. And, I dont know if it is necessary to leave the VMS Browser. I always leave it on. If these instructions are a bit off, its because I am on my computer that doesn't have chankast.