Dysprosium
Graphics Designer
I've been meaning to pick myself up a wireless router, and I managed to find a good deal on a LinkSys setup. A wireless G router, with a USB connector (Not a card.), since that would be easier to setup. Although I'm having a bit of trouble with it.
The drivers that came with either the router or the usb (Both are installed.) seem to be colliding and disabling the connector from gaining internet access. It can find the router perfectly. When I switched to Windows Zero Configuration, it connected immediately; the problem is, I need to manually turn on Windows' settings every time I boot up my PC.
Should I uninstall the LinkSys drivers and risk incompatibilities, or leave them and do this quick patch job? All of the documents state to not use the hardware unless the drivers are installed, although the router isn't even plugged into the PC. ;p
Thanks.
The drivers that came with either the router or the usb (Both are installed.) seem to be colliding and disabling the connector from gaining internet access. It can find the router perfectly. When I switched to Windows Zero Configuration, it connected immediately; the problem is, I need to manually turn on Windows' settings every time I boot up my PC.
Should I uninstall the LinkSys drivers and risk incompatibilities, or leave them and do this quick patch job? All of the documents state to not use the hardware unless the drivers are installed, although the router isn't even plugged into the PC. ;p
Thanks.