So I recently purchased a Mayflash N64 controller usb adapter. I went through several tutorials to figure out how to set it up. I calibrated it on windows (currently using XP) and then went into Project64 1.6 and attempted to further calibrate it. Windows recognizes the controllers, due to the fact that I can use the "test" tab on the windows calibration setup. When I get to Project 64 I have the "controller is plugged in" tab checked and everything else setup. I used both inputs of N-rage and Jabo and neither seem to work in Project 64. I reset everything and even tried it on a different computer (one that had Windows 7) but with the same result. The controller will not respond once Project 64 is open and an emulation is running, but for some reason windows recognizes that the controllers are there. If anyone has any idea as to what is going on i would appreciate some help. Thank you.