Cannot get Saitek p2500 to rumble with nRage 1.82

[supremebob]

Good day,

I currently can't seem to configure a new saitek p2500 properly with 1964 and n rage 1.82a input plugin. Analog sticks and buttons work fine but the rumble section stays gray even after selecting rumble pack and "Cyborg Force Rumble pad" in the device tab. I do not have those problems with a PS-USB V converter. Any help would be greatly appreciated.

Thanks

Robert

[ggab]

drivers update??
Control panel/game options, is it a config page??
do u get Rumble in another PC games, or emulators like ePSX??

[supremebob]

To the best of my knowledge I installed the latest drivers. However it seems that I am unable to use force feedback in any game. even though I followed installation instructions. I reinstalled 1964 but no luck

Any suggestions?

Robert

[ScottJC]

I was never able to get it to rumble either to be honest, I stopped trying, I aint too fussy anyway.

[ggab]

do u have DX 9.0c?
and try with Device/Rumble's section... maybe it's a special config for your PAD...

[liteuser]

Mines working fine here , I just tested with nfl blitz , the rumble is strong on that one, In controller pak tab , I have RawData checked and the scroll set to rumble pak. In devices, I have rumble on constant force nothing else , no modifiers nothing. The driver version on my cd says SD3.2, I'm very happy with mine. I did have to restart my PC however to install the drivers. Maybe its the drivers. If your keyboard is usb or you have a lot of usb things attached ,that could drain the power supply. Iv had this problem with other rumble pads.Just trying to help.

Edit: I noticed you said n rage 1.82a. My version says n rage direct-input8 V2 1.80a.

[Trpj3k]

Hi!
I`m having the same problem with the rumblepak like Bob.
But I am using PJ64 instead of 1964.
I have the newest drivers for my P2500.
on my nrage plugin it isn`t possible to change the Rumble-Power or switch between constant, ramp or direct force.
Any Ideas?
SupremeBob if your Rumble works now, could you tell me what youve done?

Greetz Trpj3k

[cooliscool]

Same here, my p2500 works fine with rumble. Try using constant rumble.. it's the only one which works for me.

Great pad btw.

[Trpj3k]

constant force is checked, but as i said I can`t switch, or do anything, the rumble-option is grey
btw, can you tell me some games where i can test properly if my rumble works?
Or maybe a tool, where you can test your pad, because my pad is new and I don`t have any PC games with forcefeedback

[liteuser]

You can test your rumble in control panel gaming options. If that does'nt work make sure the drivers are installed correctly or try a restart and switch usb ports .